TIntegrated rotary peelinging and cutting machine is set according to the thickness of 1-2 mm before leaving the factory. If you want to change the thickness of the veneer in the later stage, you must first adjust the pressure of the rotary cutting machine.
Use a triangular ruler (500 * 250mm) to lean against the upper and inner sides of the double knurling of the rotary cutting machine, and use a 150mm ruler to stand against the upper side of the single knurling to observe the value at the junction of the lower edge of the triangular ruler and the ruler. When the leather thickness is 1-2 mm, take 35mm-36mm. If the leather thickness is less than 1mm, the reading value will increase accordingly. If the leather thickness is more than 2.0mm, the reading value will decrease accordingly. If you want to increase the pressure of the rotary cutting machine, add shims between the single box on both sides and the cutter shoulder; When the pressure decreases, just reduce the gasket.
