When installing the rotary peeling blade on the wood rotary peeling machine, the two sides of the rotary knife must be kept at the same height. Put the rotary knife into the slot, first tighten one of the nuts, and adjust the support screws to make the knife height at both ends appropriate. The middle of the machine blade of the anti-bending roller does not need to be raised, and all oysters are fastened. Use a ruler to measure the distance between the two ends. If they are consistent, it can be used for rotary peeling veneer production.
Return the knife to the maximum diameter of the rotary cutting wood segment, and measure its initial posterior angle with a protractor. If the initial back angle does not match the initial back angle specified in the rotary cutting process, the eccentric disc can be adjusted by the adjustment device to make the initial back angle equal to the value specified in the rotary cutting process; open the knife to the wood core, and then Measure the final posterior angle and observe whether the range of the posterior angle varies with the diameter of the wood segment. If you do not have a back angle measuring instrument, you must adjust the back angle by experience after changing the knife. When cutting, pay attention to observe whether the knife is stable and observe the bright width of the friction part between the blade and the surface of the wood segment to determine whether it is appropriate.
Whether the installation of the rotary cutter smoothly affects the service life of the rotary cutter. If the rotary cutter is not installed properly, the rotary cutter is unstable and unbalanced, and the produced veneer will have quality problems, uneven thickness, or cause rotary Damage to the cutting blade.
