How to adjust the blade of veneer peeling machine with card to ensure our economic development, but how to adjust the blade?
1. Loosen the compression bolts on both sides of the single box (single flower roller table) of the rotary cutting machine, hold the inserting knife and the single flower roller with a feeler gauge, and adjust the adjusting screws at both ends of the single box, so that the gap between the cutter and the rotary roller is equal to or slightly greater than the thickness of the peeled leather.
2. Use a feeler gauge to check the gap between the cutter and the knuckle roller to see whether the two ends are consistent. If not, adjust the adjusting wires on both sides of the cutter table to make the knife seams on both sides consistent.
The veneer peeling machine has the advantages of reasonable structure, saving labor and convenient operation. The rotary cutting machine is driven by thick lead screw, and the welding of thickened steel plate has the advantages of good rotary cutting uniformity. The rotary cutter is an important part of veneer cutting machine. Since the back angle of the rotary cutter changes with the diameter of the wood section in the process of rotary cutting, the diameter of the wood section should be measured at the same time when measuring the back angle of the rotary cutter, and then the rotary cutter of the rotary cutter can be installed. The height of the cutter can be adjusted ahead of time, and no need to be adjusted after the machine is installed, so the loading process is the key.
The rapid development of science and technology has greatly met our various needs. In the face of the extreme shortage of domestic resources, we can only use scientific and technological means to manufacture or replace with other things. Like the use of rotary cutting machine. We can use it to make plywood, particleboard, fiberboard and other mechanical equipment, which can replace the demand for solid wood.
