Wood rotary cutting machine manufacturers are products that we play a larger role in the wood manufacturing industry, but there will be some failures in the use process. Now let's carefully understand the knowledge in this respect?
In fact, the problems that often occur in the products are generally due to the wood veneer rolling, which is caused by the narrow knife door or too high knife rest. The solution is very simple. The ram screws and adjusting screws at both ends should be loosened, the knife door should be relaxed, the height of the cutter should be lowered, and then the screws should be tightened. In this way, the problem of wood veneer rolling can be solved. Secondly, it may be that the thickness of veneer is uneven, which is mainly due to the damage of ranging or speed measuring encoder or electronic ruler. Solution: adjust the fast forward frequency to 2Hz and observe whether the diameter change of the log is continuous. If there is still a pause, the ranging encoder is broken and needs to be replaced. If the speed of the roller is inconsistent with the actual speed, the speed encoder needs to be replaced.
The last case is that the veneer is wavy, which is usually caused by the excessive resistance of the feed. Solution: check whether the output current of frequency converter is greater than 5A when idling. If the current exceeds 5a, adjust the machine and check whether the resistance caused by poor lubrication is too large.
