How to control the thickness of veneer when using no card veneer peeling machine?
Plywood is familiar to all of us. Most of the furniture we use in our life is made of plywood. Its beauty is no less than that of solid wood furniture, and it also improves the utilization rate of wood and saves costs, which is very popular at present.
Plywood is made of multi-layer veneer laminated and pressed at high temperature, and veneer is realized by veneer peeling machine, so veneer peeling machine indirectly affects the quality of plywood. Due to the different thickness of plywood required by different customers, plywood manufacturers are required to adjust the rotary cutting machine according to the actual situation.
The adjustment method is as follows:
Usually, the lathe is set according to the thickness of 1-2mm before leaving the factory. If you want to change the thickness of the veneer later, you must first adjust the pressure of the rotary cutting machine. Use a triangle ruler (500 * 250mm) to lean against the top and inside of the double roller of the rotary cutting machine, and use a 150 mm ruler to support the top of the single roller. Observe the value at the junction of the triangle ruler and the ruler. When the leather thickness is 1-2mm, take 35mm-36mm. If the leather thickness is less than 1mm, the reading value will increase correspondingly. If the leather thickness is more than 2mm, the reading value will decrease correspondingly. If you want to increase the pressure of the rotary cutting machine, you need to increase the gasket between the single box on both sides and the shoulder of the knife. When the pressure is reduced, you can reduce the gasket.
To sum up, it is about how to control the thickness of veneer when using the card free rotary cutting machine. If you want to know about other rotary cutting machine problems, please click to view the relevant articles!
