The traditional veneer veneer rotary cutter has a card center, which can't be rotated when the diameter is smaller than a certain diameter. When the diameter of the log is smaller, the log is only supported by two claws on both sides, and the rigidity in the middle is weak, which often causes the phenomenon of knife let and knife jump. The thickness error of the rotated board is very large, and the value is low, which results in a large amount of waste and low utilization rate of the log. In order to improve the utilization rate of wood, a card free rotary cutting machine was invented.
The non card rotary cutting machine can not only continue to spin the remaining wood core of the card shaft rotary cutting machine into veneers, but also can spin the small-diameter wood into veneers, improving the utilization rate of wood. The system is more flexible and more automatic. It can accurately control the moving speed of the rotary cutter to control the thickness of the rotary cutting plate. The system is easy to operate and the single plate of the rotary cutting flows smoothly, with high precision of peeling.
